How to adjust Ruizhi headlights
Recently, hot topics on car maintenance and modification have continued to heat up across the Internet, among which "Reizhi headlight adjustment" has become one of the focuses of car owners' attention. Properly adjusting the headlights can not only improve night driving safety, but also avoid glare interference to other vehicles. This article will give you a detailed introduction to the adjustment method of Reizhi headlights based on the hot content of the past 10 days, and attach structured data for reference.
1. The necessity of adjusting Ruizhi headlights
According to recent discussions on automotive forums and social media, many Reiz owners have reported that the illumination angle of the headlights is poor, resulting in limited vision at night or frequent flashing reminders from oncoming vehicles. Properly adjusting your headlights can solve the following problems:
2. Preparations before adjustment
According to the suggestions of popular car bloggers in the past 10 days, you need to prepare the following tools and conditions to adjust Reizhi headlights:
| Tools/Conditions | illustrate |
|---|---|
| Phillips screwdriver | Screws for adjusting headlights |
| level ground | Vehicles must be parked on flat roads |
| Wall or special ruler | Used to measure light height |
| vehicle empty state | There is no heavy object in the trunk and the fuel tank is half full. |
3. Detailed explanation of the adjustment steps of Ruizhi headlights
Based on the practical experience shared by recent car owners, the adjustment steps are as follows:
| step | Operating Instructions |
|---|---|
| 1. Positioning adjustment screw | Open the hood and locate the vertical/horizontal adjustment screws on the rear of the headlights (usually marked "UP/DOWN" and "L/R") |
| 2. Measure the reference height | Aim the front of the car at a distance of 3-5 meters against the wall and record the center height of the low beam light beam (it is recommended to be 60-75cm above the ground) |
| 3. Adjust vertical angle | Use a screwdriver to rotate the vertical adjustment screw so that the center of the beam is 1-2cm below the reference line. |
| 4. Adjust horizontal angle | The left and right beams should intersect 12-15 meters directly in front of the vehicle to avoid outward expansion. |
| 5. Test effect | Actual road test at night, fine-tuning according to the irradiation range |
4. Answers to recent popular questions
According to the latest discussion thread of Autohome, the following high-frequency questions are sorted out:
| question | solution |
|---|---|
| Lights are scattered after adjustment | Check whether the lampshade is aging and replace the headlight assembly if necessary |
| Automatic adjustment function fails | It is necessary to use a professional diagnostic tool to reset the headlight control module |
| Unable to adjust focus after modifying LED | Confirm that the bulb model matches. Some sub-factory parts need to be equipped with decoders. |
5. Precautions and extension suggestions
The Douyin hot list shows that there has been an increase in recent cases of failing annual inspections due to improper adjustment of headlights. Special attention should be paid to:
Through the above structured data and step analysis, I believe you can easily complete the precise adjustment of Reizhi headlights. If you need more professional services, you can refer to the latest release of the CHEDI APP"Top 50 lighting modification shops nationwide in 2023"The list selects certified stores.
check the details
check the details
en
